1. The pellet unit should be used in a dry room, and not in places where the atmosphere contains corrosive gases such as acids.

2. Regularly check the parts to see if the work is normal. Check once a month. The contents of the inspection include worm gear, worm, bolts on lubrication block, wood pellet machine, bearing and other movable parts to see if they are flexible in rotation and wear. Repair it in time and no longer continue to use it.

3. After the pellet unit is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the hopper (only for some pellet units), then install it and prepare for the next use.

4. When the roller moves back and forth during work, the M10 screw on the bearing block should be adjusted to the proper position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the proper position, adjust the gap so that the bearing does not make a noise, turn the pulley by hand, and the tension is appropriate. If it is too tight or too loose, the machine may be damaged.

5. If it is out of service for too long, the whole body of the pellet unit must be wiped and cleaned, and the smooth surface of the machine parts must be coated with anti-rust oil and covered with a cloth canopy.

As long as the above work is done, the failure of the pellet machine can be greatly reduced, so that the efficiency of the pellet machine can reach the highest level.